After breaking in (lol, mostly 3/4 to full throttle for 1 tank) and extensive upgrades and modding, I finally took out my new DR to do some therapeutic bashing! Car runs great! All of the upgrades below were well worth it.
My time out was cut short due to the stupid plastic steering servo horn breaking during a jump. Needless to say, aluminum horns are on order.
List of upgrades thus far (way more on its way, damn UPS!!!!!!)
JetPro rear mount tuned pipe
DDM modified Walbro 990 carb
Team Chase carb diaphragm filter
DDM Tall billet intake
DDM 1" velocity stack
TGN triple air filter
Savox SV-1271SG throttle servo (direct fit)
Savox SV-0235MG steering servo (took a whole lot of modding and fabrication to make this servo fit! Its 66mm long! NOT A DIRECT DROP IN!!!)
Airtronics RX-461 telemetry receiver
KillerRC super bee kill switch
KillerRC 7.4V 6000mah LiPo battery
NGK spark plug
8K clutch
Outerwears flywheel, air filter and pull-start pre filters
Parts on the way
Desperado wheels with bow-tie tires
Vertigo 8mm extended baja wheel adapters (have these, but don't have the wheels yet)
Aluminum complete font and rear suspension parts (control arms, hub carriers, turn buckles, etc)
Aluminum servo saver
Aluminum front and rear diff cases
Aluminum servo horns.
RCR X-treme pull start rope
Thanks for everyones help!
My time out was cut short due to the stupid plastic steering servo horn breaking during a jump. Needless to say, aluminum horns are on order.
List of upgrades thus far (way more on its way, damn UPS!!!!!!)
JetPro rear mount tuned pipe
DDM modified Walbro 990 carb
Team Chase carb diaphragm filter
DDM Tall billet intake
DDM 1" velocity stack
TGN triple air filter
Savox SV-1271SG throttle servo (direct fit)
Savox SV-0235MG steering servo (took a whole lot of modding and fabrication to make this servo fit! Its 66mm long! NOT A DIRECT DROP IN!!!)
Airtronics RX-461 telemetry receiver
KillerRC super bee kill switch
KillerRC 7.4V 6000mah LiPo battery
NGK spark plug
8K clutch
Outerwears flywheel, air filter and pull-start pre filters
Parts on the way
Desperado wheels with bow-tie tires
Vertigo 8mm extended baja wheel adapters (have these, but don't have the wheels yet)
Aluminum complete font and rear suspension parts (control arms, hub carriers, turn buckles, etc)
Aluminum servo saver
Aluminum front and rear diff cases
Aluminum servo horns.
RCR X-treme pull start rope
Thanks for everyones help!
Last edited by a moderator: