servo failsafe question

[topblissgt]

I am changing out the stock servos on my Sons chimera for hi tech servos and the throttle one is making me go 'hmmm'. I set up the hpi controller as per instructions and when I turn off the controller, the old servo went into full brake, as a failsafe. Now no matter what I do, it goes to full throttle. Any ideas?

 

[Deluge]

You have to reverse the throttle channel then reset the failsafe.

 

[Deluge]

I'm guessing you had to reverse the throttle channel for the new servo? You have to rebind and reset the failsafe.

 

[topblissgt]

yes its in reverse.. so I should rebind and reset the failsafe completely?

okay.. Redid the whole binding and failsafe setup and it works. Thanks bud!