KILLGORE
Active Member
- Messages
- 27
- Location
- Raleigh NC
Once I recieved my truck I immediiately did some research on the Rampage Forum and I knew what I wanted to do and what needed to be done first. I have owned the truck less than two weeks and have got a few things done so far.
Stern-CNC Belt Drive 1-1
Venom 5000mah NIMH Battery
Flysky FS-IT4S
Turnigy Reciever Switch for LED Light
Apex RC LED Light
Dynamite Kill Switch
Aluminum Roll Cage
Flywheel Dust Cover
Baha Filter with Pre Filter
On first startup it fired up on two pulls. I am impressed with how it runs and starts so far. Break in was painfully slow but worth it. I am running Royal Purple synthetic and NGK plugs. I took out all screws as advised by many posts on here and used blue Locktite on them. Future upgrades include a CPI pipe, walbro 990 carb, hub adapters for different wheels and a Fast Eddys bearing kit. Any advise would be much appreciated. I am loving this truck so far.
Stern-CNC Belt Drive 1-1
Venom 5000mah NIMH Battery
Flysky FS-IT4S
Turnigy Reciever Switch for LED Light
Apex RC LED Light
Dynamite Kill Switch
Aluminum Roll Cage
Flywheel Dust Cover
Baha Filter with Pre Filter
On first startup it fired up on two pulls. I am impressed with how it runs and starts so far. Break in was painfully slow but worth it. I am running Royal Purple synthetic and NGK plugs. I took out all screws as advised by many posts on here and used blue Locktite on them. Future upgrades include a CPI pipe, walbro 990 carb, hub adapters for different wheels and a Fast Eddys bearing kit. Any advise would be much appreciated. I am loving this truck so far.
Last edited: