Kaz the Minotaur
Senior Member
- Messages
- 609
- Location
- Central PA
I've had my XB-E roller for a while now. The electronics are ordered from Kershaw. I will be using his motor mount with the stock spur. I bought 11 and 12T pinions and I've having the stock 10T pinion bored out to 8mm. I am going with a Leopard 5692 730 KV on 12S through a FighterCat Racing 16S 300A buggy controller.
I widened the stock battery trays to hold my Zippy 6S 5000mah 40C batteries but they won't work as I didn't take into account the amount that the side guards protrude in. I fabbed up some flat plates to hold the battery with super velcro and velcro straps.
I'm using a FlySky FS-GT3B radio. 2S 800mah LiPo to power the servo direct and the BEC. That little LiPo will fit nicely where the stock ESC was.
I widened the stock battery trays to hold my Zippy 6S 5000mah 40C batteries but they won't work as I didn't take into account the amount that the side guards protrude in. I fabbed up some flat plates to hold the battery with super velcro and velcro straps.
I'm using a FlySky FS-GT3B radio. 2S 800mah LiPo to power the servo direct and the BEC. That little LiPo will fit nicely where the stock ESC was.