ParkerNT
Senior Member
- Messages
- 106
- Location
- McCreary Co. KY
It finally got here! This thing is a beastie Even after seeing pics and vids of this thing I was still dumbfounded when I pulled it outa the box. It's HUGE!
Haven't run it yet, and sadly no pics yet either. But I have put some stuff on it and done some body work. Installed a chrome air filter with blue alum. vel stack, some blue shock socks and a side Dom. pipe. Put some steal gears on it to, but that's another story for another thread (see the susp. dr-train forum for that)
I lowered the body mounts by four holes...might go on down as low as it'll go, looks so much better than sittin up crazy high. Lucked out too, got the last one in stock at DDM, they didn't have the a clear body for it, so they threw me a slightly used painted body and will send me a new clear body as soon as they get one...free. So, I ended up with a free basher body. Messed it up just a bit when I went to cuttin on it to lower it, but now I know what not to do to the clear one when it gets here.
I liked to never got the throtle and brake linkage installed...but I think it's right. However, there were no screws to fasten the dual steering servo arms. There were two extra in the bag with the throtle setup, but they won't screw into the white plastic gears on the steering servos. Any suggestions? Maybe I'm just putting my weight into it...
All in all, great looking truck, seems solid as a rock and looking forward to firing this sucker up and gettin it dirty.
Parker
Haven't run it yet, and sadly no pics yet either. But I have put some stuff on it and done some body work. Installed a chrome air filter with blue alum. vel stack, some blue shock socks and a side Dom. pipe. Put some steal gears on it to, but that's another story for another thread (see the susp. dr-train forum for that)
I lowered the body mounts by four holes...might go on down as low as it'll go, looks so much better than sittin up crazy high. Lucked out too, got the last one in stock at DDM, they didn't have the a clear body for it, so they threw me a slightly used painted body and will send me a new clear body as soon as they get one...free. So, I ended up with a free basher body. Messed it up just a bit when I went to cuttin on it to lower it, but now I know what not to do to the clear one when it gets here.
I liked to never got the throtle and brake linkage installed...but I think it's right. However, there were no screws to fasten the dual steering servo arms. There were two extra in the bag with the throtle setup, but they won't screw into the white plastic gears on the steering servos. Any suggestions? Maybe I'm just putting my weight into it...
All in all, great looking truck, seems solid as a rock and looking forward to firing this sucker up and gettin it dirty.
Parker