Replaced both steering servos and throttle servo yesterday. Little bit of buzzing noise from throttle servo. Everything was going well until today. I set it on the ground started the truck, drove it out of the garage and down the driveway. Turned it left then right was driving it back to me and smoke started pouring out of left side steering servo. After taking it back apart the bottom of the servo had a melted spot on it. WTH happened? You think it was a bad servo or something I did wrong?
Sorry for the long rant but this made me a little upset. 2 brand new Hitec
HS-5765-MH steering servo and one lasted less than 10 minutes.
Sorry for the long rant but this made me a little upset. 2 brand new Hitec
HS-5765-MH steering servo and one lasted less than 10 minutes.