Kaz the Minotaur
Senior Member
- Messages
- 609
- Location
- Central PA
I took off the plastic carb mounting block, the brown one that mounts to the engine, and the carb mounts to it. I noticed a small, factory made, hole on the lower half of the intake, in the center, to the left of the lower mounting bolt hole. This hole has a matching passage way through the mounting block that lines up with a small hole on the carb. The small carb hole is centered below the buterfly. It doesn't look like it goes anywhere. What is this hole? Will it hurt anything if I get RTV gasket maker in it?
There isn't much room below the gasket to spread a bead of gasket maker around.
There isn't much room below the gasket to spread a bead of gasket maker around.