xb gearing

[andyken]

I seem to have good low end power, but want more top end speed.


What can I do for more top end? I have a 30cc with a jet pro pipe...stock everything.

 

[cordy]

You could reverse your a & b gear for a little more top speed,or get the belt drive.

 

[Guest]

+1

Also you will want to invest in some wheel adapters. You then can run the Baja wheels/tires. They are a little larger in diameter which will also give you a bit more top end speed.

 

[andyken]

What is the best price/place for adapters?

 

[andyken]

You could reverse your a & b gear for a little more top speed,or get the belt drive.

I see...do I swap the out side set or the inside? ...or both?

 

[Deluge]

The A and B gears...

 

[Deluge]

What is the best price/place for adapters?

Here...

RampageHopUps Adapters

You don't have to worry about what size the threads on the axle are. Just remove the square and put them on.

 

[andyken]

Just found the bearing on the idler b/c shaft is gone...and egg shaped the hole.

 

[andyken]

On my b-c shaft, the square alluminum gear mount has no bearings?

Should I get part #07135? It has bearings...?

 

[Deluge]

Hmmm. That's an odd place to put bearings. If they're missing, just buy the bearings. They're 8x16x5's.

 

[andyken]

Hmmm. That's an odd place to put bearings. If they're missing, just buy the bearings. They're 8x16x5's.

Right now the square part the gears fit to just spins on the shaft...?

The manual showed bearings in the sqare part.

I ordered a new one with bearings

 

[andyken]

Hmmm. That's an odd place to put bearings. If they're missing, just buy the bearings. They're 8x16x5's.

They are not missing...it is just a square of alluminum no bearings?

 

[Guest]

The center shaft gear square has bearings. The other 2 do not.

 

[Deluge]

That's what I figured. He said the B/C shaft didn't have bearings, so I thought maybe they just forgot to throw them on.

 

[andyken]

Where is the best place to get the aluminum gear plate?