Dieselaw
Member
- Messages
- 52
- Location
- Chandler az
Well i installed my new HiTec throttle servo. The model that is nearly an exact swap with the stock servo. Everytging went well. Pulled the old, installed the new, removed the servo horns, set controller to neutral on my throttle adjustment, set controls in "normal", turned in controller, turned on receiver, setting servo to center. Then i installed the horns with linkage ( linkage was same setting as stock). All looked well. I went to start it up. It started , so i adjusted my idle speed with my controller. It seemed to be backwards, the car wanted to take of when i hit the brakes. I read about this so i redid my servo setup with my contols in reverse. Started it back up, and all seemed well. I gave it some throttle and it responded, but when i hit the brakes it TOOK OFF. Wide open until i hit the throttle again, then it would start acting normal ( as best i can tell). Let me know what you you guys think, and sorry for the long write up.