Steering servo arm

[Lizardking]

I just noticed the stock steering servo arm doesn't fit the Hitec servo. The arm is splines are to large. What servo arm are you guys using?

 

[mooman007uk]

one of the ones that came with the hitec, there's one single sided arm that's just right...just have to make the hole bigger

 

[Lizardking]

Cool, are they strong enough? They seem pretty thin compared to the stock one.


Thanks,


Shane

 

[kryptonite]

i saw that too. they are kinda skinny minnies. you can hop on tower hobbies site and get an alum arm for a few bucks. i don't use hitechs. every body likes them but i run scaner-rc servos.


http://www.scanner-rc.com/specification/HDS-9960MG.pdf

 

[Lizardking]

That looks like the same spline/tooth config.

 

[Lizardking]

Whare can you buy those at?

 

[mooman007uk]

mine have held up ok but i got duals so they've only got half the effort...may be too skinny for single steer

 

[Lizardking]

That's what I'm thinking. Getting ready to put on the steel gears. How tight should the nuts for the gears be? Is there a torque spec?

 

[kryptonite]

i didnt over tight'in. just snugged up. the nylo-nuts keep them on good

 

[Lizardking]

I noticed when I put on B gears the washer is loose but the nut is tight. The others ones are tight up against the gears. weird....

 

[RampageHopUps]

I use blue loctite on the nuts too.

 

[NEWCARNAGE]

Beach throttle has a nice servo arm it fits hitec. It has the screw hole to mount to servo but also has a pinch bolt to tighten down on the arm its called big daddy or something like that just had to cut the mounting hole a little bigger to get stock tie rod on.

 

[beachthrottle]

Here is what I use


http://www.largescalerc.com/index.asp?PageAction=VIEWPROD&ProdID=1861