Kaz the Minotaur
Senior Member
- Messages
- 609
- Location
- Central PA
My steering is binding and I think it is coming from the post with the integrated servo saver.
As many of you know I am converting to brushless. I flipped the front top plate over so the brace would be on the other side of the drive shaft. So now what was the top is the bottom. The counter sunk part of the hole is in contact with the top of the post. I also seem to be having trouble with the screws. They must both be screwed into the same internal post. When I try to take out the top screw the bottom one comes out also.
Thoughts?
As many of you know I am converting to brushless. I flipped the front top plate over so the brace would be on the other side of the drive shaft. So now what was the top is the bottom. The counter sunk part of the hole is in contact with the top of the post. I also seem to be having trouble with the screws. They must both be screwed into the same internal post. When I try to take out the top screw the bottom one comes out also.
Thoughts?
