i think motor is fried

[erdoganog]

been having few issues here and there and now finnaly it wont even fire up at al


checked the spark plug for sparks i can see it sparking when i turn it over


checked to see if fuel is going through yes it is since it eventually gets flooded


tried 5 times unflooded and then floods eventually


checked the fuel tank cap


all the gaskets are stock brand new everything is tight all the bolts

 

[erdoganog]

im close to giving up either i sell as roller or show me some engine options i can use

ive seen couple on ddm im not looking for high performance just on a budget...

few i found.

http://www.davesmotors.com/s.nl/it.A/id.4415/.f

http://www.davesmotors.com/s.nl/it.A/id.4449/.f

and a stock hpi engine

http://www.davesmotors.com/bb429

what should i do..

 

[GoffeeRedCat]

What's your tune?? Is your tank vented??

 

[erdoganog]

What's your tune?? Is your tank vented??

i tuned it a while back last summer time

and no i don't have the tank vent mod but it always ran fine till outa nowhere

 

[andyken]

go back to factory setting to see if it starts

 

[andyken]

Does it have a killer b?

 

[Guest]

When there is a problem starting, it is good to go back to the base carb settings.

 

[erdoganog]

When there is a problem starting, it is good to go back to the base carb settings.

whats the base carb settings? or is it in the manual i could look for it

 

[erdoganog]

Does it have a killer b?

no it doesn't

 

[kbreaux100]

the base carb settings are 1 1/4 on the low and 1 1/2 on the high. also check and see if your filter is getting soaked with fuel, i had that problem and it was cuz my cap wasnt venting correctly

 

[erdoganog]

the base carb settings are 1 1/4 on the low and 1 1/2 on the high. also check and see if your filter is getting soaked with fuel, i had that problem and it was cuz my cap wasnt venting correctly

i cleaned the cap and the tiny hole stuck a needle thru it

and it just keeps flooding eventually i unflood and try same results

put in a new plug on it also..

 

[Ildy666]

U need to make a positive vent.i don't think a needle is good enough.use some fuel line and a vac line fitting...

 

[Stumpdiggitty]

Blown head gasket? Had that prob last summer...