Volcano EPX PRO steering issue

ARSEEGZS

Member
Messages
8
Recently upgraded all aluminum suspension components as well as the servo saver and I put lock tight on the screws. Everything was fine after a couple test runs only having to tighten the steering connector bar screws. Now that I was comfortable with everything being tight I went out for a good rip session, after a good while with the truck running fine the steering started acting up where it wouldn't turn right or the steering would get stuck turning right until I accelerated hard them down up. I stopped playing with it at that point. So now the steering doesn't work at all and it seems like there's play inside the steering servo. What's gone wrong here?
 

ARSEEGZS

Member
Messages
8
Thanks, thats what it was so I got an upgraded servo with metal gears. Problem solved, now if I can just stop breaking other shit.
 

BoostedTRex

Member
Messages
20
Thanks, thats what it was so I got an upgraded servo with metal gears. Problem solved...
What did you go with for the new servo? I’m going to have replace mine eventually. For now I’ll take the gear out and mill a new hole 180° from where the pin is currently and flip it around.
 

Members online

No members online now.

Latest posts

Top