Ok so I know this may not be a "new" topic but from the ones Ive read I havent found a surefire solution to my problem. For one the screws Im talking about cannot use the dremmel method without damaging the chassis because they are countersunk (flat with the chassis) so thats out. I also bought a tap bit from HD just seemed to strip the crap out of it more.
Any viable solutions out there? I saw a post that said use a torx head. Ok but is it a special torx head or just put a torx head in there and go to work to further stripping the crap out of it. Any more detail would be appreciated.
Also another post said to drill the head off and then use pliers. Im not sure if i understand that method. How do i drill the head off. If i drill the head off therell be nothing for me to grab with the pliers because its countersunk in the chassis.
I have at least 3 to 4 countersunk chassis screws thats stripped (SMH)
Any help would be appreciated.
Thx
Any viable solutions out there? I saw a post that said use a torx head. Ok but is it a special torx head or just put a torx head in there and go to work to further stripping the crap out of it. Any more detail would be appreciated.
Also another post said to drill the head off and then use pliers. Im not sure if i understand that method. How do i drill the head off. If i drill the head off therell be nothing for me to grab with the pliers because its countersunk in the chassis.
I have at least 3 to 4 countersunk chassis screws thats stripped (SMH)
Any help would be appreciated.
Thx