just revs up won’t move after engine replacement

Bigdogjp

New Member
Messages
1
Replaced engine on a rampage MT and now it just revs up and won’t move.
 

Haroldbee

Well-Known Member
Messages
47
Maybe it's not revving high enough to engage the clutch bell. Fix suggestion #1: Increase the idle speed and lean-out the high-end needle by turning it clockwise by small increments.

Check to ensure the clutch is okay--that a spring is not broken. Replace clutch if necessary.

Check to ensure all the transmission gears are engaging and transferring to the drive-train. Tighten loose set screws on gears if necessary.

Hope something helps.

PEACE!
 

Dobber72

Well-Known Member
Messages
61
Location
Booneville
Replaced engine on a rampage MT and now it just revs up and won’t move.
Had the same thing happen to me and the problem was I over tighten the two bolts that hold the clutch on and it wouldn't let it engage so loosen off those and you'll be good to go. I had to get used to not torquing the crap out of everything on mine. That should be your problem before you go and do 15 other things to it.
 

Members online

Latest posts

Top