Just noticed im leaking nitro between the heat sinc and the block.i was told it would be the head shim,so i have removed it and it doesn't look cracked or warped to me.it allstarted when i flipped the buggy and was running too lean on the day.by the time i got to buggy to switch it off,it was too hot.anyway,any suggestions?
-
Welcome to RedcatRampageForum! Are you a Redcat fan? If so you're in luck as you've have arrived to the biggest and best RedcatRampage RC community.
Come join our community and ask your questions, show off your Recat RCs and share your experience!
Force. 32 head shim!
- Thread starter scott
- Start date
Ildy666
Senior Member
- Messages
- 2,321
- Location
- Haskell NJ
Retorque it and c what happens...
rcgasser
Senior Member
- Messages
- 2,383
- Location
- Atlanta, GA
When you flipped it you could have striped the head screws they are easy to strip I would try some new head screws and when you are tightening the heat sink back down make sure you tighten each screw a little at a time in an X pattern to make sure the heat sink goes down flat onto the head.
Create an account or login to comment
You must be a member in order to leave a comment
Create account
Create an account on our community. It's easy!
Log in
Already have an account? Log in here.