1. If you're having login issues, please try resetting your password.
    Dismiss Notice

Register and gain access to Discussions, Reviews, Tech Tips, How to Articles, and much more - on the largest Redcat Rampage RC community for Redcat RC enthusiasts that covers all aspects of the Redcat brand!

Register Today It's free! This box will disappear once registered!

For those who have removed the fuel tank and switched sides for the ddm pipe is the process easy?

Discussion in 'General Rampage Discussions' started by westsiderkg, Feb 5, 2018.

  1. westsiderkg

    westsiderkg Member

    Joined:
    Dec 4, 2017
    Messages:
    48
    Likes Received:
    7
    For those who have removed the fuel tank and switched sides for the ddm pipe is the process easy?



    Also, are the factory fuel lines long enough after switching sides to reach the carb?



    Thanks!
     
  2. Phill

    Phill Well-Known Member

    Joined:
    Jul 19, 2013
    Messages:
    1,766
    Likes Received:
    27
    Location:
    Yeppoon QLD Au
    Dunno about the pipe but you can buy fuel line by the foot.
    Buy line that you can see through so you can see where the fuel is going.
    Which vehicle is it?
     
  3. westsiderkg

    westsiderkg Member

    Joined:
    Dec 4, 2017
    Messages:
    48
    Likes Received:
    7
    rampage mt v3.

    What fuel line do you recommend phill?
     
  4. Phill

    Phill Well-Known Member

    Joined:
    Jul 19, 2013
    Messages:
    1,766
    Likes Received:
    27
    Location:
    Yeppoon QLD Au
    Some recommend specific brands but I just get the yellow stuff from DDM.
    orry but I don't have any experience with the MT
     
  5. Bigpopa64

    Bigpopa64 Member

    Joined:
    May 28, 2017
    Messages:
    43
    Likes Received:
    5
    It's a pain in the ass you have to pull the rear gear box off the drive shaft runs threw the gas tank but it's not to bad.Jave you put blue locktite on all your screws that is metal on metal
     
  6. G-Man

    G-Man Junior Member

    Joined:
    May 15, 2016
    Messages:
    559
    Likes Received:
    53
    Location:
    Pittsburgh,PA
    It isn't too bad the hang up is the center driveshaft. So the rear diff assembly has to come out. The stock fuel lines reach just fine
     
  7. westsiderkg

    westsiderkg Member

    Joined:
    Dec 4, 2017
    Messages:
    48
    Likes Received:
    7
    Thanks all. any good directions or videos on how to remove the rear diff? 1st time doing so and appreciate the guidance.
     
  8. SmokinToad

    SmokinToad New Member

    Joined:
    Mar 26, 2017
    Messages:
    25
    Likes Received:
    7
    Its fairly easy. 9 screws and the whole rear end assembly comes off. I used blue fuel line to match the truck. don't mine the disarray. In the process of replacing the clutch
     

    Attached Files:

Loading...
  • Welcome to Redcat Rampage Forum

    Redcat Rampage Forum is a Redcat Rampage RC fan site that was started to give Redcat RampageRC enthusiasts a place to come together and discuss and share their experiences with the entire Redcat RC product line.

    We welcome all Redcat Rampage RC enthusiasts, both new and old, racers and bashers that share a common goal - a willingness to help and learn.
  • Disclaimer