Petrolheadz100
Well-Known Member
- Messages
- 237
Inspecting my transmission gear plate bearings and i noticed when i spin the clutch bell theres a bit of wobble, what can be done to correct this or do these shafts wear out
Welcome to RedcatRampageForum! Are you a Redcat fan? If so you're in luck as you've have arrived to the biggest and best RedcatRampage RC community.
Come join our community and ask your questions, show off your Recat RCs and share your experience!
Not that I know of.is there any way to tighten the shaft so it doesn't wobble,
I believe that was it since the inner part of the bell had scrapes rubbing against he clutch when it went inward. since then i been running a new bell and its solid, 0 wobble....when your plate melted and the clutch bell was hitting - it might have messed up the clutch bell at that time- just a wild guess--
Why is it pitted?Awesome I put one in mine @7.4v. Been raining so much I haven't tried it. Check out this pic of my clutch bell shaft View attachment 14200
It's actually twisted a bit. Guess cheap steel used broWhy is it pitted?
Register and gain access to Discussions, Reviews, Tech Tips, How to Articles, and much more - on the largest Redcat Rampage RC community for Redcat RC enthusiasts that covers all aspects of the Redcat brand!
Register Today It's free! This box will disappear once registered!