Slimneill
Member
- Messages
- 81
- Location
- Port Elgin, Ontario, Canada
I?m trying to do a full tear down and lube of my MT and I?m trying to replace the bearing in the brake assembly but I can?t seem to get the two shafts apart that are connected by the square piece with two set screws. The set screws are out but I can?t get the two shafts to come out of the Center Diff shaft connecter part. And I need the shafts apart so that I can take out the bearing on the plastic support part.
See diagram. Need to remove the red parts especially 50074 from the green parts.
Has anyone else had this issue? Should I be making a special tool to get them apart?
Thanks,
Dan
See diagram. Need to remove the red parts especially 50074 from the green parts.
Has anyone else had this issue? Should I be making a special tool to get them apart?
Thanks,
Dan