Belt drive system

Pricesredcatmt

Active Member
Messages
37
Location
Lafayette
Can I ask everyone what is the best gas mixing to use I've hear many many different mixs lol but after break in , when in the engine idles it sounds great but when I try to take off it takes a min to clear out then it runs fine,
 

Attachments

Pricesredcatmt

Active Member
Messages
37
Location
Lafayette
25to1 is what I've been doing but people say you want just a little smoke not alot, but mine smoke like crazy and I have the carb needles set to factory,
 

Phill

Well-Known Member
Messages
2,240
Location
Yeppoon QLD Au
Factory settings are just a starting point to get it going.
Now it's time to tune it for running.
If you have too much smoke you're running rich and need to turn the LSN clockwise.
As you lean it the idle will increase so you may need to adjust the idle screw as well.
Use small adjustments 1/16 of a turn at a time.
You should see a little smoke so you know you're getting oil to the motor but not a lot.
25:1 is fine.
 

Pricesredcatmt

Active Member
Messages
37
Location
Lafayette
I didn't shim them it look pretty straight but I will look at it before trying it out when weather clears up, I installed new super bee kill switch also took the Dynamite kill switch out, it was working fine but hear a lot of bad things about it
 

Members online

Latest posts

Top