servo saver

Hi I have an xb and the servo saver adjuster(I think that's what its called) keeps self adjusting all the way to the top and then I turn like a tractor trailer why is this happening and how can I fix it thx.

I really need a stiffer spring for the steering servo saver...

Anyone have an extra bushing in their parts bin. I fixed my Ackerman & somehow created a new problem. Lol. It's for the saver post opposite (driver side) of the servo saver but I think they're both the same. Maybe a hardware store will have one? They are closed now tho.

Anyone know if u can just order the bushing in the top of the servo saver?

Since the 7075rc steering post arent ready yet!! Does anyone have any experience with the Aluminum set from redcat for the XT??

Im looking for the correct part number from redcat or elsewhere for the dual servo saver in all aluminum. I ordered one from them for the MT, but it was a single. I saw a couple of trucks with these somewhere on the net, but no reference to where they were obtained from. Before I return them, if...

Not sure if this will help anyone but as I was setting up my servo to be the best way I noticed there was way to much stress on the servo from the lack of movement. So what I did was add another spring with the small washer in between the two spring (to stop the springs from binding eachother)...

I'am looking for bearings for my servo saver post who had these the bearing measure 7x10x3 mm :rolleyes:

So here's the story... My brother was driving my DR V3 4X4 on the 4th of July and lightly crashed the right wheel which attaches to the steering servo arm into his parked tractor. The servo gears broke in the stock servo. I replaced with a Hitec 5745 last night. Should I be concerned that I...

If anyone have a extra servo saver all I need is the one side with the spring I busted the arm off one of them on my duel servo setup. If you do let me know thx....Don

I have the new MT that has twin stearing servos. I can't seem to find an aluminum set. All there is out there is the single servo style. On all your guys nice trucks you only run one servo. Do i need two Servos? I bet that add some weight to the car.

Just waiting on some shafts that hold the steering linkage. Any ideas, its not offered from redcat..... it's the 2 shafts and the four bushings. I need one shaft and 2 bushings, until then i and out of commision.. :(

whats the cure for a slipping stearing servo saver? on both my rigs they come lose after making just a few turns. hasnt happened before but i had them both apart and now they wont stay tight and just back out. -thread lock? -or is something else the problem, like mounting screws too tight?

Every time i set my servo saver to where i like it (the not too soft but not too stiff section) it backs all the way up to the top (loosest setting). Anyone else having this problem? Other than locktite is there any way to keep this from back off, but not lose the adjustability.

What is the proper setting for the ServoSaver? MOfroggy