rampage xt

I just picked up a XT-E and I noticed a lot of the chassis parts list that they are for the XT, but don't mention the XT-E specifically. Other than the obvious, are most of the parts interchangeable? Wondering specifically about bearings. Thanks Sent from my iPhone using Tapatalk

Hello all, i am new to the forum and to 5th scale. I was wondering if anyone could help me out. I currently just bought a rampage xt, but love the look of the chimera. What is needed to make the conversion from xt to the chimera. Any help would be greatly appreciated.

Here's my new Redcat Rampage XT-E with a Kershaw Designs motor mount, Leopard 5692 1000KV motor with 10t pinion (41 spur), Hobbywing Max5 200a ESC, 8s powered (two 4s lipos in series). I haven't run it yet, will start testing tonight :) Thanks for all the knowledgable people on...

Is anyone 100% sure the vertigo hpi rear axel adapters. Will fit on a MT V3. Also will my stock wheel nut. Work or do I have to buy the nuts separate. I remember reading about it in here somewhere but not sure what exactly the Answer was. Thanks for any help.

I'm considering an ESC upgrade and leaning towards the Hobbywing 200a max5 8s capable ezrun unit (I've had a few Hobbywing esc's and really like them). My question: Can I run this upgraded ESC on 8s with the stock 980kv motor? Will the motor grenade or just keep on trucking. I hear a lot of...

Hello everyone, I finally got my first 1/5 scale RC, a Rampage XT. I have been wanting one for several years. I flooded the engine on my first start up attempt, but I have since figured out the way to start it (I hope). But the one thing i did not do that i should have is check all bolts...

New owner here. I love the truck, but want to make this machine wheelie from a stop. Couple questions: 1. Will better Lipos (higher C rating) accomplish this with added punch and timing on the stock motor? I'm not sure what the factory pinion size it, but maybe a smaller pinion (one or two...

Check out my redcat rampage xt aluminium hop ups on youtube at Donald smith redcat rampage xt aluminium hop ups..

Hey everyone, I got a little careless and crashed my xt. Some of my front end is shot but I was wondering if there is a complete rebuild kit for my front end. I mean for the steering and all that. Please let me know because I want to get this thing back out there. This RC is really fun...

I just got my new rampage xt and bought some hop ups with it. I never used the stock carb swapped it out immediately. Myproblem is when I go to break the carb walbro 990lever push's to far back and stalls/kills the truck. I tryed adjusting the levers but nothing if it moves 4 mm it turns off...

Need recommendation for battery pack. Plan on adding led lights. Any suggestions

Hi. I got a new xt for Christmas. The radio has three small dials. I know one is to fine tune throttle and one to fine tune zteering. What is the other one for. I want to use the third channel to run some leds. Is this possible.

I was just curious, cause it was around this time last year I was in the market for a 5th scale. Did the math on the HPI's and price was ridiculous (15cc Octane too.) don't do any racing so the Losi was out of the question. Then I came across Redcat. I wanted a heavy duty 4x4 truck so I landed...

Got my Rampage from Rob this week and wanted to post up. Have only had nitro in the past. Ordered a slew of upgrades from DDM and wasn't planning to drive it until they came but I took it out for some short break in spins today. Two 10 minute heat cycles down and I'm ready to let it rip once...

I need some help, I have a XT and for reason the right rear wheel bolt, the bolt that holds the wheel on keeps coming off no matter how tight i put it on? Any ideas on why it loosens and comes off? Adam

Hi I have a rampage xt. Wasat an idle all of a sudden it took off wide open. Finally flipped over Iran to it turned it off. White smoke was pouring out of throttle servo and trying g to bend linkage. Replaced servo with Jr 126 oz metal gear did same thing after two tanks of fuel. This time hit a...

All the sudden, out of nowhere my xt will not start, will not even think about srarting. Last time I ran it, about 2 weeks ago it sputtered a little but kept running. I had a busy day and had to just put it up and now I cannot get it to start at all. Checked the spark plug, pulled the carburetor...

Watching videos, the XT looks like it is quicker than the MT, or is it my imagination? Does the XT come with a hop up making it quicker than the MT?

Anyone know if a Hummer body will work off of another brand and fit on the Redcat MT or XT (or is it XB?)

Just bought a 2 speed transmission off ebay and so far it fit great but I think something internally is backwards. Neither one of the gears will engage at all unless I'm in reverse wich my truck does not even have. I already took off 2nd gear and looked at the main paw that engages 2nd gear but...