dunerunner

I just picked up a used Dune Runner. All the electronics seem to work fine, it is getting gas, just no spark! Any ideas as to where to check next? Thanks Chris

Gents, I just picked up a used Dune Runner. All the electronics seem to work fine, I just can't get it to start. Pulled the spark plug and it's getting gas, but to spark. Any idea where to look now? Thanks ahead for you help. Chris

Dunerunner clone???? http://www.ebay.com/ulk/itm/252144944656

well i really liked what a buddy of mine did with his dunrunner and i seen a killer deal on a brand new one on craigslist so i got it and started to build it. this is it untouched this is next to the rampage as a slider as you can see it is a lot longer lol

Well, finally got my new Dunerunner running, and was having a great time breaking in the engine this afternoon. After about 15 minutes of the car running great, it just quit on me. I checked and still had fuel left in the tank. I started it again and the revs were all over the place. Also, I...

Hello everyone, Newbie here with gas RC vehicles. I can not get my Dune Runner to fire up. I ended up flooding the engine so now I have to wait a few days before trying again unfortunately. I've searched these forums and have found a few other topics similar to mine, but unfortunately being...

Hi Guys, I purchased a beautiful Dunerunner 32cc just a week ago, started doing engine breakin process as specified in book 1/20 ratio with 1/4 throttle. Just after 45min of drive it started increasing acceleration without even me applying any and vehicle starts rolling itself. Even servo was...

So, this happened: The little screw came loose, the pin went out, did some small damage to the chassis and basically left me with a useless dogbone. Did this happen to anyone else? Am I supposed to open all these small screws on all dogbones and loctite them?...

Hi guys, As my Tarmac Busters are nearing their end, I'm looking ahead to my next set of tires. I was perfectly happy with every aspect of the Tarmac Busters, except their durability. I especially LOVE the street look they gave my DR but I can honestly say that, unless I control myself, I can...

After installing 2 speed transmission should the clutch bell turn with gears?

I just installed 2 speed however after tightening everything down I am unable to get the wheels to move and also unable to move gear is this normal?

Is there any way to fix the way the wheels slightly wobble from left to right?

Is there a plastic cover that will fit over 2 speed? The stock is to small. Also does anyone know how get Savox 0235 servo to fit in dunerunner? The servo is larger than the stock one.

Is there a body available for the Dunerunner that covers the wheels? The only track in my area is only for onroad vehicles and they won't let me use the DR because of the open wheels.

Hey guys, I ran into some issues tuning my carb. I have the 32cc with a Jetpro and a WT-1107 carb and I can't seem to get it running fine. There are a few problems: 1. It's way slower than it was with the stock carb. It's actually even slower off the line than it was in 100% stock setup...

Hey guys, anyone know of a mod that would allow me to raise my dunerunner's rear? It's sitting quite a bit lower than the front (even more so since I added the gigantic jetpro exhaust hanging from the rear) and it's way softer (pushing on the rear with my hand and you can barely feel it push...

Anyone know the default settings for the Walbro WT-1107 by chance?

I want to know which of this servo will work on my dunerunner HS-805BB or HS-5645MG and if they are direct fit or I need to mod anything.

My friend did this to his Dune Runner aka Bajer.

I went today to by 2 stroke oil i was going to by castro 927 but they dint have it in stock its supposed to get to store tomorrow. But on guy toll me that golden spectro 2 oil was a good. I want to know if any 1 have use that oil.