Search results

Likewise, interested to see where this one leads

I cant get the camber I want. I seams like the axles are too long or the Front lower suspension arms (50004) are too short. I wounder if it is worth using the rear suspension arm holders on the front? When suspension is fully compressed, the universal drive joints are binding.

Is the outer steering arm bent down perhaps? sometimes happens when you hit something

Must be cold where you are Pete

can't get century #362 spring here in NZ tried this but might need to try and sleeve down or drill out bottom suspension arm to 5mm to mount the new rod end (might become the new weak point)

Going to try a Century springs #362 and maybe recoil the thread on a 6mm Rovan baja lower shaft support to 5mm?

I have my MT running as low as possible. I find that geometry is not ideal and I break the bottom shaft supports ALOT. Is there anything better or is there a complete new shock to use for a upgrade? So in Brief am I better to upgrade or replace? Phill I think the only way you'll get live...

I've installed Temp and rpm on My gas MT to use with my 4PLS. The temp was easy to install, the Hall sensor for the rpm took a-bit of work. I used a piece of 3mm aluminum and put it under the kill switch using the fly wheel mag as the trigger

Looks good, explain the process of dying the beadlocks.

Just finished balancing my wheels. One of them took 50grams of counter weight, that heaps for a toy wheel. My actual racecar used less

Apparently this is normal with new Digital servo's and 2s lipos 7.4volt

Have you got it set to TFH-HI?

G-Man I've got the same set-up as you I think? My servo's don't sound to happy. Futaba 4PLS Specktrum S9020 Hitec 7954SH Futaba R304SB RX 2s Lipo 7.4v I will run telemetry rpm and temp when They arrive. Maybe I've got the RX mode wrong? what do you have yours set as? Both servos making a...

Or maybe it was the battery charger.

They were almost like glued together, They are supposed to twist, that's why there is a spring at the top. I just backed off the ring on the spring to unload the tension. Then I used a bit of brute strength and twisted the arms which in turn opened the gap between the two half's and greased...

Well my steering servo was the first thing to break. Found that the servo savers need to be stripped and greased if you want them to do their job. Tr battery lasted all of about 5mins just spent another US$500+ on new gear, I hope you guys are right with your suggested upgrades for servos and...

Got my New super bee kill switch, Quick question, I have the Rampage MT v3. It come with a 2ch Trans but a 3ch receiver. It has dual steering servos via slitter cable out of ch1. throttle is out of ch2. I have ordered new 4 ch Radio gear but in the mean time want to run the motor in. My...

https://www.ebay.com/itm/Belt-Drive-V8-0-9-1-1-fur-HSP-Himoto-Amewi-Pitbull-X-Redcat-Tuning-HD-/162665139670? So this one wont work? I just wish they would reply to my emails

thanks for that. which 2 or 3 ratios would you recommend for the badlands tyres for short circuit bashing and the standard tyres. Do I need the gear plate from the v3 Pro? I have tried emailing them but no answer (in German as well)

which hex adapter did you use for mx43's. was it just any of the 24mm ones mentioned as above. Do you need the extenders? are these worth a go http://kershawdesigns.com/Redcat-24mmHubs.htm