Search results

Looking for more aggressive mud tire for hopped up MT....been looking with a lot of it might work, does anyone have a set up that will work? Thank you!

Could you take a picture of your setup? I can't get the left side (the side the battery box is on) to work

Yes or some way to run dual box shaped servos

Does anybody make a non curved servo adapter for running two non curved steering servos? Advise on how to do that without a lot of work. I want to run two big ones instead on just 1, I have futaba mount for one side already

What is the largest servo size that will fit in Rampage MT?

Is there an aftermarket gear I can get to reduce the gearing further? I have a modded one engine and I'm trying to get it to wheelie

Does this look right? There super hard to turn and when I let off the gas the rc stoops without brakes.

Could someone walk me through what gear goes where to lower(more low end)?

Lots of threads about gearing but I'm still clueless. I am looking to lower gearing of my Mt pro. The belt drive is too.much for stock motor w/pipe. How don't get the most low end power in Lamont's terms please!!!!!?

Hey, does anyone make a aluminum diff gear carrier for the Mt? I have the aluminum case. Second question the front went together perfect but the rear I can't get the gear mesh right in the aluminum housing does anyone remember what shims they used ? It rolls okay then hits a rough spot with all...

How much to make me one?

Mt pro bearings

I did hit a curb and it should have broken but when it's driving hard it streaches a bit plus that's the last link that has not been upgraded.

Thank you for the reply, I was looking for a strong upgrade for the factory.

I have a rear jetpro for my Rampage MT, is there another pipe that gives more power that the jetpro pipe? I have the rest covered.

Do you know what size or one that fits? I ordered three from China and they were all wrong and it cost more to return than the part cost. Sorry for the trouble but going to one servo really put strain on this link

Dang,I wanted something that looks real clean.. almost factory, I'm probably not good enough for that Fab work.

My rampage mt caught fire when grass got under the engine plastic does anybody make fenders or a higher frame to block out some of the debris? I have a screen over the pullstart too.

A belt drive from eBay does it if you want to go that route

Strange question: even with the screens they allowed enough grass to get to the engine to start smoking and almost catch fire, other than keep an extinguisher handy do you have any tips? I didn't run it long either and land with grass is about our only option around here.